YASKAWA SGM-A3 User Manual page 433

7.2.7 The Core on the Cable
1) Attach the core on the cable as shown below:
• Core specifications
Core Model
Quantity
Manufacturer
• Cable line and the line position where the core is attached:
Cable Line
Line Position
7.2.8 Wiring
1) The following diagram shows the wiring example for motor with brake.
The noise filter and the core are shown in the same figure.
* When eatrth plate is not used, polish the mounted noise filter part with sand paper to expose
the metal. Then, ground the noise filter securely on the panel.
ESD−SR−25
1
Turn 1.5
Tokin Corp.
PG Line
Near the Servopack side
EARTH
PLATE*
NOISE
FILTER
(1.97 in.)
NOISE
FILTER
(3.94 in.)
(1.97 in.)
(3.94 in.) (1.97 in.)
(3.94 in.)
7.2 Measures to Satisfy the Requirements of EMC Directive
Note: 1.5 turn is as shown below:
I/O Signal Input Line
Near the host controller and
Servopack
POWER
SUPPLY
FOR
BRAKE
(1.97 in.)
1.5 TURN
CORE
(78.7 in.)
CORE
1.5 TURN
1.5 TURN
CORE
CONTROL
BOX
CABLE
CORE
MOTOR WITH BRAKE
421
7