Figure 159 Switch Port Flowctrl Enable Command Example - ZyXEL Communications MSC1000G User Manual

The following example turns on the subtending 1 Gigabit Ethernet interface.
ras> switch port enable sub1
28.9.3 switch port flowctrl disable Command
Syntax:
switch port flowctrl disable <giga-port>
This command turns off flow control on a Gigabit Ethernet interface.
The following example turns off the flow control on the subtending 1 Gigabit Ethernet
interface.
ras> switch port flowctrl disable sub1
28.9.4 switch port flowctrl enable Command
Syntax:
switch port flowctrl enable <giga-port>
This command turns on flow control on a Gigabit Ethernet interface.
The following example turns on the flow control on the subtending 1 Gigabit Ethernet
interface.

Figure 159 switch port flowctrl enable Command Example

ras> switch port flowctrl enable sub1
28.9.5 switch port frametype Command
Syntax:
switch port frametype <giga-port> all|tag
where
all|tag
This command sets the specified port to accept all Ethernet frames or only those with an IEEE
802.1Q VLAN tag.
Chapter 28 switch Commands
=
Specifies all Ethernet frames (tagged and untagged) or only tagged
Ethernet frames.
MSC1000G User's Guide
475