Enable Or Disable Sending Of Snmp Traps On A Port; Technical Reference - ZyXEL Communications GS1920v2 Series User Manual

24.5 Enable or Disable Sending of SNMP Traps on a Port

Click SYSTEM > SNMP > SNMP Trap Port to view the screen as shown. Use this screen to set whether a trap
received on the ports would be sent to the SNMP manager.
Figure 102 SYSTEM > SNMP > SNMP Trap Port
The following table describes the labels in this screen.
Table 57 SYSTEM > SNMP > SNMP Trap Port
LABEL
Options
Port
*
Active
Apply
Cancel

24.6 Technical Reference

This section provides technical background information on the topics discussed in this chapter.
Chapter 24 SNMP
DESCRIPTION
Select the trap type you want to configure here.
This field displays a port number.
Settings in this row apply to all ports.
Use this row only if you want to make some of the settings the same for all ports. Use this row
first to set the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Select this check box to enable the trap type of SNMP traps on this port. The Switch sends the
related traps received on this port to the SNMP manager.
Clear this check box to disable the sending of SNMP traps on this port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
GS1920v2 Series User's Guide
146