Enable Or Disable Sending Of Snmp Traps On A Port - ZyXEL Communications XMG1930 Series User Manual

The following table describes the labels in this screen.
Table 163 Management > Access Control > SNMP > Trap Group
LABEL
Trap Destination IP
Type
Options
Apply
Cancel

38.3.2 Enable or Disable Sending of SNMP Traps on a Port

From the SNMP > Trap Group screen, click Port to view the screen as shown. Use this screen to set
whether a trap received on the ports would be sent to the SNMP manager.
Figure 225 Management > Access Control > SNMP > Trap Group > Port
The following table describes the labels in this screen.
Table 164 Management > Access Control > SNMP > Trap Group > Port
LABEL
Option
Port
Chapter 38 Access Control
DESCRIPTION
Select one of your configured trap destination IP addresses. These are the IP addresses of the
SNMP managers. You must first configure a trap destination IP address in the SNMP Setting
screen.
Use the rest of the screen to select which traps the Switch sends to that SNMP manager.
Select the categories of SNMP traps that the Switch is to send to the SNMP manager.
Select the individual SNMP traps that the Switch is to send to the SNMP station.
The traps are grouped by category. Selecting a category automatically selects all of the
category's traps. Clear the check boxes for individual traps that you do not want the Switch
to send to the SNMP station. Clearing a category's check box automatically clears all of the
category's trap check boxes (the Switch only sends traps from selected categories).
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Select the trap type you want to configure here.
This field displays a port number.
XMG1930 Series User's Guide
318