Activating Hessen Protocol - Teledyne T300 Operation Manual

Teledyne API – Model T300/T300M CO Analyzer

6.7.2.2. ACTIVATING HESSEN PROTOCOL

Use the PREV and
NEXT buttons to
between the
available modes.
Activate / Deactivate
the HESSEN mode
by toggling the ON /
OFF button.
06864B DCN6314
Once the COMM port has been properly configured, the next step in configuring the
T300/T300M to operate over a Hessen protocol network is to activate the Hessen mode
for COMM ports and configure the communication parameters for the port(s)
appropriately.
To activate the Hessen Protocol, press:
SAMPLE RANGE=50.0 PPM
<TST TST> CAL
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG
SETUP X.X COMMUNICATIONS MENU
ID COM1 COM2
SETUP X.X COM1 MODE:0
<SET SET> EDIT
SETUP X.X COM1 QUIET MODE:OFF
PREV NEXT OFF
Continue pressing NEXT until ...
SETUP X.X COM1 HESSEN PROTOCOL: OFF
PREV NEXT OFF
SETUP X.X COM1 HESSEN PROTOCOL: ON
PREV NEXT ON
SETUP X.X COM1 MODE:16
<SET SET> EDIT
SETUP X.X COMMUNICATIONS MENU
ID HESN COM1 COM2
Communications Setup and Operation
CO= XX.XX
SETUP
MORE EXIT
EXIT
EXIT
Combined Mode ID
displayed here.
EXIT
EXIT
ENTR EXIT
EXIT discards the new
ENTR EXIT
ENTR accepts the
EXIT
EXIT
setting.
new setting.
159