Mode/Select Switch - Mitsubishi Electric MELSEC iQ-R Series User Manual

MODE/SELECT switch

With the MODE/SELECT switch, the mode can be switched between the operation selection mode and normal operation
mode, and the operation selected in the operation selection mode can be performed.
The 'notification/unmount' and 'information display on the dot matrix LED' can be performed in the operation selection mode.
Make sure that the C Controller module is in normal operation before selecting its operation.
Selecting and performing an operation
The following shows how to select and perform the operation.
The mode is switched to the normal operation mode by holding the MODE/SELECT switch in the MODE
position while selecting an operation.
*1
LED display Operation
EVENT Notifies an event to the user program. (Default)
SD UNMOUNT Unmounts the SD memory card forcibly.
USB UNMOUNT Unmounts the USB Mass Storage Class-compliant device forcibly.
SD/USB Unmounts the SD memory card and USB Mass Storage Class-compliant device forcibly.
UNMOUNT
*3
USER Displays contents specified by the user on the dot matrix LED. (Default)
*4
ERROR Displays an error code on the dot matrix LED.
*5
CH1 Displays IP address of the Ethernet port (CH1) on the dot matrix LED.
*5
CH2 Displays IP address of the Ethernet port (CH2) on the dot matrix LED.
6 PROCEDURE BEFORE OPERATION
42
6.5 Switch Operation
(1)
(1)
1.
Hold the MODE/SELECT switch (1) in the MODE position.
2.
The selectable operation is displayed on the dot matrix LED.
(In the operation selection mode, the lighting status of LED
display is reversed.)
3.
Release the MODE/SELECT switch (1) and put it back to the
center position.
4.
Set the MODE/SELECT switch (1) to the SELECT position.
Every time the switch is set to the SELECT position, the value
of mode displayed on the dot matrix LED is changed. Repeat
this switch movement until the desired operation is displayed
on the dot matrix LED.
5.
Hold the MODE/SELECT switch (1) in the SELECT position.
6.
The selected operation is performed.
Operation at execution
*2
Notification/unmount
Information display on the dot
matrix LED