Juniper ACX1000 Configuration Manual page 258

ACX Series Universal Access Router Configuration Guide
200
Configure the IP address of the neighboring router or switch, interface forming the
2.
layer 2 circuit and the identifier for the layer 2 circuit.
[edit protocol l2circuit]
user@host# set neighbor ip-address interface
interface-name-fpc-slot/pic-slot/port.interface-unit-number virtual-circuit-id
virtual-circuit-id;
NOTE: To configure T1 interface as the layer 2 circuit, replace e1 with t1 in
the below statement.
For example:
[edit protocol l2circuit]
user@host# set neighbor 10.255.0.6 interface e1-1/0/0.0 virtual-circuit-id 1
To verify the configuration use the
3.
hierarchy level.
[edit protocols l2circuit]
user@host# show
neighbor 10.255.0.6 {
interface e1-1/0/0.0 {
virtual-circuit-id 1;
}
}
After the customer edge (CE)-bound interfaces (for both PE routers) are configured with
proper encapsulation, payload size, and other parameters, the two PE routers try to
establish a pseudowire with Pseudowire Emulation Edge-to-Edge (PWE3) signaling
extensions. The following pseudowire interface configurations are disabled or ignored
for TDM pseudowires:
ignore-encapsulation
mtu
The supported pseudowire types are:
0x0011 Structure-Agnostic E1 over Packet
0x0012 Structure-Agnostic T1 (DS1) over Packet
When the local interface parameters match the received parameters, and the pseudowire
type and control word bit are equal, the pseudowire is established.
For detailed information about configuring TDM pseudowire, see the Junos OS VPNs
Library for Routing Devices.
For detailed information about PICs, see the PIC Guide for your router.
command at the
show [edit protocols l2circuit]
Copyright © 2017, Juniper Networks, Inc.