Juniper ACX1000 Configuration Manual page 356

ACX Series Universal Access Router Configuration Guide
Results
Verification
Purpose
Action
Meaning
298
[edit protocols ptp slave]
user@host# edit hybrid
Configure the IP address of the master clock as 2.2.2.2 , and the interface ge-1/2/3.0
3.
for hybrid mode on the slave.
[edit protocols ptp slave]
user@host# set interface ge-1/2/3.0 unicast-mode clock-source 2.2.2.2
Display the results of the configuration of hybrid mode with a user-defined mapping of
the PTP clock class to the ESMC quality level:
[edit protocols ptp slave]
user@host# show
clock-class-to-quality-level-mapping {
quality-level prc {
clock-class 80;
}
}
interface ge-1/2/3.0 unicast-mode clock-source 2.2.2.2
hybrid
Verifying That the Router Is Operating in Hybrid Mode on page 298
Verifying the Quality Level Change on the Transmit Side on page 299
Verifying Global Information Parameters After Mapping of the PTP Clock Class to the
ESMC Quality Level in Hybrid Mode on page 299
Verifying Global Information Parameters After Configuring User-Defined Mapping of
the PTP Clock Class to the ESMC Quality Level in Hybrid Mode on page 300
Verifying That the Router Is Operating in Hybrid Mode
Verify the current mode of operation of the slave.
In operational mode, enter the
configuration and current mode of operation of the slave.
In operational mode, enter the
source to Synchronous Ethernet interface mappings.
In operational mode, enter the
hybrid mode operational status.
The output displays the current configuration and current mode of operation of the slave.
For information about the
hybrid.
run show ptp hybrid command to display the current
run show ptp hybrid config
run show ptp hybrid status
operational command, see
run show ptp hybrid
command to display the PTP
command to display the current
show ptp
Copyright © 2017, Juniper Networks, Inc.