Ima Test Pattern Procedure; Ima Group Alarms And Group Defects - Juniper ACX1000 Configuration Manual

IMA Test Pattern Procedure

IMA Group Alarms and Group Defects

Table 29: IMA Group Alarms with IMA Standard Requirement Numbers
Alarm
Start-up-FE
Config-Aborted
Config-Aborted-FE
Insufficient-Links
Insufficient-Links-FE
Blocked-FE
Copyright © 2017, Juniper Networks, Inc.
Configure an ATM interface with one T1 link or one E1 link with the
interface-name ima-link-options group-id g
The interface-name variable refers to the T1 or E1 interface to be set as an IMA interface
link and the variable refers to the port in the at-x/y/g interface.
g
To delete the configured IMA link, you must execute the following configuration
commands:
delete interfaces interface-name encapsulation ima
delete interfaces interface-name ima-link-options group g
A test pattern procedure is supported for IMA to test the ATM, T1, and E1 interfaces for
irregularities. You can use the CLI to start and end the test pattern procedure.
The following options can be set according to the requirement at the
interface-name ima-group-options test-procedure]
interface interface-name
—IMA test pattern that can be set from 1 through 254
pattern number
—Length of the IMA test pattern that can be set from 1 second through
period number
4,294,967,294 seconds. Default is 10 seconds.
To perform the test pattern procedure, execute the
and
ima-test-start test interface interface-name ima-test-stop
commands to start and to stop the IMA test, respectively.
Table 29 on page 177 shows the supported IMA group alarms and their associated IMA
standard requirement numbers. This is displayed in the group status and control field of
an ICP cell.
configuration command.
hierarchy level:
—Interface name of the IMA link to test.
test interface interface-name
IMA Standard Requirement Number
R-145
R-146
R-147
R-148
R-149
R-150
Chapter 6: Configuring ATM Interfaces
set interfaces
[edit interface
operational mode
177