Juniper ACX1000 Configuration Manual page 204

ACX Series Universal Access Router Configuration Guide
Configuration
CLI Quick
Configuration
Step-by-Step
Procedure
146
To configure PoE on an ACX2000 router:
To quickly configure this example, copy the following commands, paste them into a text
file, remove any line breaks, change any details necessary to match your network
configuration, and then copy and paste the commands into the CLI at the
level.
set poe management high-power guard-band 19
set poe interface ge-0/1/3 priority high maximum-power 65 telemetries
The following example requires you to navigate various levels in the configuration
hierarchy. For instructions on how to do that, see Using the CLI Editor in Configuration
Mode in the CLI User Guide.
To configure PoE:
Set the PoE management mode to
1.
[edit]
user@host# set poe management high-power
NOTE:
Set the PoE management mode to
requirement is more than 32 W and up to 65 W. If the power
requirement is less than or equal to 32 W, then you do not need to set
the PoE management mode to
The default management mode is
sourcing equipment can deliver power up to 32 W.
Reserve power wattage in case of a spike in PoE consumption.
2.
[edit]
user@host# set poe guard-band 19
Enable PoE.
3.
[edit]
user@host# edit poe interface ge-0/1/3
Set the power port priority.
4.
[edit poe interface ge-0/1/3]
user@host# set priority high
Set the maximum PoE power for a port.
5.
.
high-power
only when the power
high-power
.
high-power
. In this mode, the power
static
Copyright © 2017, Juniper Networks, Inc.
hierarchy
[edit]