Juniper ACX1000 Configuration Manual page 342

ACX Series Universal Access Router Configuration Guide
284
[edit interfaces ge-0/2/0]
user@host#set unit 0 family inet
Specify the address for the logical interface
8.
[edit interfaces ge-0/2/0 unit 0 family inet]
user@host#set address 110.1.1.2/24
Configure the stateful interface, and enter edit mode for the interface.
9.
[edit interfaces]
user@host#edit ge-0/2/1
Configure a description for the interface.
10.
[edit interfaces ge-0/2/1]
user@host#set description to-ACX2
Configure a logical unit and specify the protocol family.
11.
[edit interfaces ge-0/2/1]
user@host#set unit 0 family inet
Specify the address for the logical interface
12.
[edit interfaces ge-0/2/1 unit 0 family inet]
user@host#set address 110.2.1.1/24
Configure the clock mode as boundary clock.
13.
[edit protocols ptp]
user@host# set clock-mode boundary
Specify the PTP domain value.
14.
[edit protocols ptp]
user@host# set domain 110
Configure the local slave interface from which the boundary master receives time
15.
and passes it on to the configured clock clients.
[edit protocols ptp]
user@host# edit slave interface ge-0/2/0.0
Configure the upstream unicast PTP master clock source parameters.
16.
[edit protocols ptp slave interface ge-0/2/0.0]
user@host# edit unicast-mode
Configure the encapsulation type for PTP packet transport.
17.
[edit protocols ptp slave interface ge-0/2/0.0 unicast-mode]
user@host# set transport ipv4
Copyright © 2017, Juniper Networks, Inc.