Ima Group Statistics - Juniper ACX1000 Configuration Manual

Table 31: IMA Link Alarms with IMA Standard Requirement Numbers (continued)
Alarm
Tx-Mis-Connected
Rx-Mis-Connected
Tx-Unusable-FE
Rx-Unusable-FE
Link Fault
Table 32: IMA Link Defects with IMA Standard Requirement Numbers
Defect
LIF
LODS
RFI-IMA
Tx-Mis-Connected
Rx-Mis-Connected
Tx-Unusable-FE
Rx-Unusable-FE
Link Fault

IMA Group Statistics

Copyright © 2017, Juniper Networks, Inc.
IMA Standard Requirement
Number
R-141
R-142
R-143
R-144
An IMA unit management is defined by SNMP MIBs.
Table 32 on page 179 shows the supported IMA link defects that are reported to the unit
management with their associated IMA standard requirement numbers.
IMA Standard Requirement
Number
R-138
R-139
R-140
R-141
R-142
R-143
R-144
You can use the show interfaces
Near-end failure count
Far-end failure count
Receive end (R ) faulty cells due to address mismatch
x
Chapter 6: Configuring ATM Interfaces
Description
Transmit misconnected
Receive misconnected
Transmit unusable far end
Receive unusable far end
Link fault
Description
Loss of IMA frame
Link out of delay synchronization
Remote defect/failure
Transmit misconnected
Receive misconnected
Transmit unusable far end
Receive unusable far end
Link fault
command to display the following IMA group statistics:
179