Configuring Ct1 Interface Down To Ds Channels - Juniper ACX1000 Configuration Manual

Configuring CT1 Interface Down to DS channels

Copyright © 2017, Juniper Networks, Inc.
To configure a channelized T1 (CT1) interface down to DS channels, include the
statement at the
[edit interfaces ct1-mpc-slot/mic-slot/port-number]
NOTE: To configure a CE1 interface down to DS channels, replace
in the following procedure.
ce1
In configuration mode, go to the
1.
hierarchy level.
[edit]
user@host# edit interfaces ct1-mpc-slot/mic-slot/port-number
For example:
[edit]
user@host# edit interfaces ct1-1/0/0
Configure the sublevel interface partition index and the time slots, and set the interface
2.
type as .
ds
[edit interfaces ct1-mpc-slot/mic-slot/port-number]
user@host# set partition partition-number timeslots timeslots interface-type ds
For example:
[edit interfaces ct1-1/0/0]
user@host# set partition 1 timeslots 1-4 interface-type ds
NOTE: You can assign multiple time slots on a CT1 interface. In the
command, separate the time slots by commas and do not include spaces
between them. For example:
[edit interfaces ct1-1/0/0]
user@host# set partition 1 timeslots 1-4,9,22-24 interface-type ds
To verify this configuration, use the
hierarchy level.
[edit interfaces ct1-1/0/0]
user@host# show
partition 1 timeslots 1-4 interface-type ds;
An NxDS0 interface can be configured from a CT1 interface. Here N represents the number
of time slots on the CT1 interface. The value of N is:
1 through 24 when a DS0 interface is configured from a CT1 interface.
1 through 31 when a DS0 interface is configured from a CE1 interface.
Chapter 8: Configuring CESoPSN Support on Interfaces
[edit interfaces ct1-mpc-slot/mic-slot/port-number]
command at the
show [edit interfaces ct1-1/0/0]
partition
hierarchy level:
ct1 with
set
221