ACX Series Universal Access Router Configuration Guide
198
For example:
[edit]
[edit interfaces e1-1/0/0]
Configure SAToP encapsulation and the logical interface for E1 interface
2.
[edit interfaces e1-1/0/0]
user@host# set encapsulation encapsulation-typeunit interface-unit-number;
For example:
[edit interfaces e1-1/0/0]
user@host# set encapsulation satop unit 0;
You do not need to configure any cross-connect circuit family because it is automatically
created for the above encapsulation.
Configuring Loopback for a T1 Interface or an E1 Interface
To configure loopback capability between the local T1 interface and the remote channel
service unit (CSU), see
"Configuring T1 Loopback Capability" on page
loopback capability between the local E1 interface and the remote channel service unit
(CSU), see
"Configuring E1 Loopback Capability" on page
NOTE:
By default, no loopback is configured.
Setting the SAToP Options
To configure SAToP options on T1/E1 interfaces:
In configuration mode, go to the
1.
level.
[edit]
user@host# edit interfaces e1-fpc-slot/pic-slot/port
For example:
[edit]
user@host# edit interfaces e1-1/0/0
Use the
command to go to the
2.
edit
[edit]
user@host# edit satop-options
In this hierarchy level, using the
3.
options:
excessive-packet-loss-rate
, and
sample-period
threshold
—Specify groups.
groups
167.
[edit interfaces e1-fpc-slot/pic-slot/port]
hierarchy level.
satop-options
command you can configure the following SAToP
set
—Set packet loss options. The options are
.
Copyright © 2017, Juniper Networks, Inc.
170. To configure
hierarchy
groups
,