Autoinstallation Process On A New Acx Series Router In Hybrid Mode - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide
Related
Documentation

Autoinstallation Process on a New ACX Series Router in Hybrid Mode

84
ACX Series Autoinstallation Overview on page 75
Before You Begin Autoinstallation on an ACX Series Universal Access Router on page 77
Autoinstallation Configuration of ACX Series Universal Access Routers on page 78
Verifying Autoinstallation on ACX Series Universal Access Routers on page 79
USB Autoinstallation on ACX Series Routers on page 80
Autoinstallation on ACX Series Routers in Hybrid Mode Overview on page 81
Autoinstallation Process on a New ACX Series Router in Hybrid Mode on page 84
Configuring Autoinstallation of ACX Series Routers in Hybrid Mode on page 87
autoinstallation on page 1442
show system autoinstallation status on page 3178
You can perform autoinstallation on a new ACX Series router in hybrid mode, which is a
combination of the USB-based autoinstallation process and the network-based
autoinstallation process.
This configuration method has the following requirements:
A management device (PC or laptop).
An external USB storage device with one of the following 16-bit or 32-bit file allocation
table (FAT) file systems:
DOS 3.0+ 16-bit FAT (up to 32 MB)
DOS 3.31+ 16-bit FAT (over 32 MB)
FAT32
FAT32, LBA-mapped
16-bit FAT, LBA-mapped
BOOTP, RARP and DHCP are the supported protocols for acquisition of IP address of
the router and TFTP, FTP, and HTTP are the supported protocols for downloading the
configuration file from an external server URL on which the configuration file is stored.
The following operations occur during autoinstallation in hybrid mode on ACX Series
routers:
Copyright © 2017, Juniper Networks, Inc.