Ima Clocking; Differential Delay; Configuring Atm Ima On Acx Series; Creating An Ima Group (Atm Interfaces) - Juniper ACX1000 Configuration Manual

Table 33: IMA Link Statistics with IMA Standard Requirement Numbers (continued)
Performance Parameter
Far-end Tx UUS
Far-end Tx failure

IMA Clocking

Differential Delay

Related
Documentation

Configuring ATM IMA on ACX Series

Creating an IMA Group (ATM Interfaces)

Copyright © 2017, Juniper Networks, Inc.
Interface clock source is applicable only to IMA links.
You can set the interface clock source as external or internal with the
at-x/y/z clocking (external | internal)
statement is not applicable to the
is a virtual interface.
You can set the maximum differential delay from 1 millisecond through 56 milliseconds
among links in an IMA group. By default, a differential delay of 25 milliseconds is set.
Execute the
set interfaces interface-name ima-group-options differential-delay delay
configuration command to set the differential delay.
Configuring ATM IMA on ACX Series on page 181
The following sections explain how to create an ATM IMA group and to configure it
according to your requirements:
Creating an IMA Group (ATM Interfaces) on page 181
Configuring Group ID for an IMA Link on a T1 Interface or an E1 Interface on page 182
Configuring ATM Encapsulation Options on page 182
Configuring IMA Group Options on page 183
To create an IMA group, perform the following steps:
In configuration mode, go to the
1.
[edit]
user@host# edit chassis
Configure the Flexible Port Concentrator (FPC) slot and the Physical Interface Card
2.
(PIC) slot as needed.
[edit chassis]
user@host# set fpc fpc-slot pic pic-slot
Chapter 6: Configuring ATM Interfaces
IMA Standard Requirement Number
R-114
–
configuration command. Note that the
interface because the IMA group it represents
at-x/y/g
hierarchy level:
[edit chassis]
set interfaces
clocking
181