Setting The Satop Encapsulation Mode - Juniper ACX1000 Configuration Manual

Setting the SAToP Encapsulation Mode

Copyright © 2017, Juniper Networks, Inc.
1
2
3
DS1 alarms : None
DS1 defects : None
SAToP configuration:
Payload size: 192
Idle pattern: 0xFF
Octet aligned: Disabled
Jitter buffer: packets: 8, latency: 7 ms, auto adjust: Disabled
Excessive packet loss rate: sample period: 10000 ms, threshold: 30%
Packet Forwarding Engine configuration:
Destination slot: 0
CoS information:
Direction : Output
CoS transmit queue
Limit
0 best-effort
none
3 network-control
none
Logical interface t1-0/0/0.0 (Index 308) (SNMP ifIndex 789) (Generation 11238)
Flags: Point-To-Point SNMP-Traps Encapsulation: TDM-CCC-SATOP
CE info
CE Tx
CE Rx
CE Rx Forwarded
CE Strayed
CE Lost
CE Malformed
CE Misinserted
CE AIS dropped
CE Dropped
CE Overrun Events
CE Underrun Events
Protocol ccc, MTU: 1504, Generation: 13130, Route table: 0
The built-in T1 and E1 interfaces must be configured with SAToP encapsulation at the
PE router so that the interworking function (IWF) can segment and encapsulate TDM
signals into SAToP packets, and in the reverse direction, to decapsulate the SAToP
packets and reconstitute them into TDM signals.
On the PE router, configure SAToP encapsulation on the physical interface:
1.
[edit interfaces (t1 | e1)–fpc/pic /port]
user@host# set encapsulation satop
For example:
[edit interfaces t1-0/0/0
user@host# set encapsulation satop
On the PE router, configure the logical interface:
2.
Chapter 7: Configuring SAToP Support on Interfaces
expedited-forwarding
assured-forwarding
network-control
Bandwidth
% bps
95 1459200
5 76800
Packets Bytes Count
0 0
0 0
0
0
0
0
0
0
0 0
0
0
Buffer Priority
% usec
95 0 low
5 0 low
195