Configuring Atm Interfaces; Atm Pseudowire Overview - Juniper ACX1000 Configuration Manual

CHAPTER 6

Configuring ATM Interfaces

ATM Pseudowire Overview

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
ATM Pseudowire Overview on page 173
Understanding ATM IMA Configuration on ACX Series Router on page 174
Configuring ATM IMA on ACX Series on page 181
Inverse Multiplexing for ATM (IMA) Overview on page 184
Configuring Inverse Multiplexing for ATM (IMA) on page 185
ATM OAM F4 and F5 Cells on ACX Series Routers on page 185
Defining the ATM OAM F5 Loopback Cell Period on page 187
Configuring the ATM OAM F5 Loopback Cell Threshold on page 188
Configuring the Timeout for Bundling of Layer 2 Circuit Cell-Relay Cells on page 188
Configuring the Layer 2 Circuit Cell-Relay Cell Maximum Overview on page 189
An Asynchronous Transfer Mode (ATM) pseudowire acts as a Layer 2 circuit or service,
which allows the migration of ATM services to an MPLS packet-switched network without
having to provision the ATM subscriber or customer edge (CE) device. When you configure
an ATM pseudowire, the network between the customer edge (CE) routers appears
transparent to the CE routers, making it seem that the CE routers are directly connected
across a time-division multiplex (TDM) leased line. ATM pseudowires are primarily used
in an ATM service provider's network to connect existing ATM switches across a higher
speed packet-switched network or to provide ATM backhaul services for remote access
to existing ATM networks.
On ACX series routers, you configure an ATM pseudowire with Layer 2 encapsulation for
Inverse Multiplexing for ATM (IMA).
Understanding Encapsulation on an Interface on page 104
Inverse Multiplexing for ATM (IMA) Overview on page 184
Configuring Inverse Multiplexing for ATM (IMA) on page 185
Pseudowire Overview for ACX Series Universal Access Routers on page 590
TDM Pseudowires Overview on page 600
Ethernet Pseudowire Overview on page 596
173