Configuring The Ptp Slave Clock Parameters - Juniper ACX1000 Configuration Manual

Configuring the PTP Slave Clock Parameters

Copyright © 2017, Juniper Networks, Inc.
and phase recovery based on received and requested timestamps from a master clock—a
grandmaster or a boundary clock master.
NOTE: In ACX Series routers, the grandmaster functionality is supported only
on ACX500 router.
To configure a PTP slave clock, complete the following tasks:
Configuring the PTP Slave Clock Parameters on page 255
Configuring the PTP Slave Clock Interface on page 257
To configure a PTP slave clock.
NOTE: The clock-class-to-quality-level-mapping quality-level
convert-clock-class-to-quality-level
supported on the QFX10002 switch.
Configure the clock mode:
1.
[edit protocols ptp]
user@host# set clock-mode (boundary | ordinary)
Configure the slave clock.
2.
[edit protocols ptp]
user@host# edit slave
(Optional) Specify the rate of announce messages that a PTP slave requests from
3.
the master during a unicast-negotiation session—from 0 through 4. The default value
is 1.
[edit protocols ptp slave]
user@host# set announce-interval announce-interval-value
NOTE: The configuration of the
only when the
protocols ptp
(Optional) Specify the number of announce messages that a slave—configured on
4.
an ACX Series router—must miss before an announce timeout is declared—from 2
through 10. The default value is 3.
[edit protocols ptp slave]
user@host# set announce-timeout announce-timeout-value
Chapter 9: Configuring Timing and Synchronization
, and
grant-duration
announce-interval
statement is also configured at the [
unicast-negotiation
] hierarchy level.
,
statements are not
statement is effective
edit
255