Setting The Cesopsn Options - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide

Setting the CESoPSN Options

216
To verify this configuration, use the
hierarchy level:
[edit interfaces ds-1/0/0:1:1:1]
user@host# show
encapsulation cesopsn;
unit 0;
You do not need to configure any circuit cross-connect family because it is automatically
created for the CESoPSN encapsulation.
To configure CESoPSN options:
In configuration mode, go to the
1.
hierarchy level.
[edit]
user@host# edit interfaces ds-fpc-slot/pic-slot/port:channel
For example:
[edit]
user@host# edit interfaces ds-1/0/0:1:1:1
Use the command to go to the
edit
2.
[edit]
user@host# edit cesopsn-options
At this hierarchy level, using the
3.
CESoPSN options:
NOTE: When you stitch pseudowires by using interworking (iw) interfaces,
the device stitching the pseudowire cannot interpret the characteristics
of the circuit because the circuits originate and terminate in other nodes.
To negotiate between the stitching point and circuit endpoints, you need
to configure the following options.
excessive-packet-loss-rate
and .
threshold
—Time required to calculate excessive packet loss rate (from 1000
sample-period
through 65,535 milliseconds).
—Percentile designating the threshold of excessive packet loss rate
threshold
(1–100 percent).
—An 8-bit hexadecimal pattern to replace TDM data in a lost packet
idle-pattern
(from 0 through 255).
jitter-buffer-latency —Time delay in the jitter buffer (from 1 through 1000
milliseconds).
command at the
show
[edit interfaces ds-fpc-slot/pic-slot/port:channel]
[edit cesopsn-options]
set command you can configure the following
—Set packet loss options. The options are
Copyright © 2017, Juniper Networks, Inc.
[edit interfaces ds-1/0/0:1:1:1]
hierarchy level.
sample-period