Juniper ACX1000 Configuration Manual page 343

Copyright © 2017, Juniper Networks, Inc.
Configure the PTP master parameters by specifying the IP address of the PTP
18.
master clock and the IP address of the local interface.
[edit protocols ptp slave interface ge-0/1/0.0 unicast-mode]
user@host# set clock-source 110.1.1.250 local-ip-address 110.1.1.2
Configure the master interface in this example.
19.
[edit protocols ptp]
user@host# edit master interface ge-0/1/4.0
On the master interface, configure multicast transmission for downstream PTP
20.
clock clients.
[edit protocols ptp master interface ge-0/1/4.0]
user@host# edit multicast-mode
On the master interface, configure the encapsulation type as Ethernet for PTP
21.
packet transport.
[edit protocols ptp master interface ge-0/2/1.0 multicast-mode]
user@host# set transport ieee-802.3
Configure the dynamic or stateful interface in this example.
22.
[edit protocols ptp]
user@host# edit stateful interface ge-0/2/1.0
On the dynamic interface, configure multicast transmission for downstream PTP
23.
clock clients.
[edit protocols ptp stateful interface ge-0/2/1.0 ]
user@host# edit multicast-mode
On the dynamic interface, configure the encapsulation type as Ethernet for PTP
24.
packet transport and the link-local multicast address to be used.
[edit protocols ptp stateful interface ge-0/2/1.0 multicast-mode]
user@host# set transport ieee-802.3 link-local
Results
In configuration mode, confirm your configuration by entering the
output does not display the intended configuration, repeat the configuration instructions
in this example to correct it.
[edit protocols ptp]
user@host# show
clock-mode boundary;
domain 110;
slave {
interface ge-0/2/0.0 {
Chapter 9: Configuring Timing and Synchronization
command. If the
show
285