Example: Disabling A Poe Interface On Acx2000 Routers - Juniper ACX1000 Configuration Manual

Example: Disabling a PoE Interface on ACX2000 Routers

Requirements
Overview
Configuration
Step-by-Step
Procedure
Verification
Copyright © 2017, Juniper Networks, Inc.
This example shows how to disable PoE on all interfaces or on a specific interface.
Requirements on page 149
Overview on page 149
Configuration on page 149
Verification on page 149
Before you begin:
Configure PoE on all interfaces. See
on page 144.
In this example, you disable PoE on all interfaces and on a specific interface, which in
this case is ge-0/1/3.
Disable PoE on all interfaces.
[edit]
user@host# set poe interface all disable
Disable PoE on a specific interface.
[edit]
user@host# set poe interface ge-0/1/3 disable
To verify the configuration is working properly, enter the
user@host> show poe interface
Interface Admin
status
ge-0/1/3 Disabled
ge-0/1/7 Disabled
user@host> show poe interface ge-0/1/3
PoE interface status:
PoE interface
Administrative status
Operational status
Power limit on the interface : 32.0 W
Priority
Chapter 4: Configuring Interfaces and Chassis
"Example: Configuring PoE on ACX2000 Routers"
Oper Max Priority
status power
Disabled 32.0W Low
Disabled 32.0W Low
: ge-0/1/3
: Disabled
: Disabled
: Low
show poe interface command.
Power Class
consumption
0.0W
0.0W
0
0
149