Before You Begin Autoinstallation On An Acx Series Universal Access Router - Juniper ACX1000 Configuration Manual

Related
Documentation

Before You Begin Autoinstallation on an ACX Series Universal Access Router

Copyright © 2017, Juniper Networks, Inc.
on the new router makes three unicast TFTP requests for
attempts fail, the router broadcasts three requests to any available TFTP server
for the file.
If the new router cannot locate
c.
or broadcasts TFTP requests for a default router configuration file called
network.conf , which contains hostname-to-IP address mapping information, to
attempt to find its hostname.
If network.conf contains no hostname entry for the new router, the autoinstallation
d.
process sends out a DNS request and attempts to resolve the new router's IP
address to a hostname.
If the new router can determine its hostname, it sends a TFTP request for the
e.
file.
hostname.conf
If the new router is unable to map its IP address to a hostname, it sends TFTP
f.
requests for the default configuration file
After the new router locates a configuration file on a TFTP server, autoinstallation
3.
downloads the file, installs the file on the router, and commits the configuration.
Before You Begin Autoinstallation on an ACX Series Universal Access Router on page 77
Autoinstallation Configuration of ACX Series Universal Access Routers on page 78
Verifying Autoinstallation on ACX Series Universal Access Routers on page 79
USB Autoinstallation on ACX Series Routers on page 80
autoinstallation on page 1442
show system autoinstallation status on page 3178
To configure a router for autoinstallation, complete the following tasks:
Make sure you have a DHCP server on your network to meet your network requirements.
Create one of the following configuration files and store it on an HTTP, FTP, or TFTP
server in the network:
A host-specific file with the name
autoinstallation. Replace
file typically contains all the configuration information necessary for the router with
this hostname.
A default configuration file named
necessary to enable you to telnet into the new router for further configuration.
Chapter 3: Configuring Autoinstallation
, the autoinstallation process unicasts
hostname.conf
router.conf
hostname.conf for each router undergoing
with the name of a router. The
hostname
router.conf with the minimum configuration
. If these
hostname.conf
.
hostname.conf
77