Configuring Cesopsn Encapsulation On Ds Interfaces; Setting The Encapsulation Mode - Juniper ACX1000 Configuration Manual

Related
Documentation

Configuring CESoPSN Encapsulation on DS Interfaces

Setting the Encapsulation Mode

Copyright © 2017, Juniper Networks, Inc.
For example:
[edit interfaces ds-1/0/0:1:1:1 ]
user@host# set encapsulation cesopsn unit 0
To verify this configuration, use the
hierarchy level.
[edit interfaces ds-1/0/0:1:1:1]
user@host# show
encapsulation cesopsn;
unit 0;
Understanding Mobile Backhaul
Configuring CESoPSN Encapsulation on DS Interfaces on page 215
This configuration applies to the mobile backhaul application shown in Mobile Backhaul
Application.
Setting the Encapsulation Mode on page 215
1.
Setting the CESoPSN Options on page 216
2.
Configuring the Pseudowire Interface on page 217
3.
To configure a DS interface on Circuit Emulation MICs with CESoPSN encapsulation at
the provider edge (PE) router:
In configuration mode, go to the
1.
hierarchy level.
[edit]
user@host# edit interfaces ds-mpc-slot/mic-slot/port<:channel>
For example:
[edit]
user@host# edit interfaces ds-1/0/0:1:1:1
Configure CESoPSN as the encapsulation type and set the logical interface for the
2.
DS interface.
[edit interfaces ds-mpc-slot/mic-slot/port<:channel>]
user@host# set encapsulation cesopsn unit logical-unit-number
For example:
[edit interfaces ds-1/0/0:1:1:1]
user@host# set encapsulation cesopsn unit 0
Chapter 8: Configuring CESoPSN Support on Interfaces
command at the
show [edit interfaces ds-1/0/0:1:1:1]
[edit interfaces ds-mpc-slot/mic-slot/port<:channel>]
215