Understanding Ethernet Ring Protection Switching Functionality - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide
Related
Documentation

Understanding Ethernet Ring Protection Switching Functionality

112
For additional information on configuring Ethernet ring protection switching on EX Series
switches, see Example: Configuring Ethernet Ring Protection Switching on EX Series
Switches.
For additional information on configuring Ethernet ring protection switching on MX Series
routers, see the Layer 2 Configuration Guide for a complete example of Ethernet rings and
information about STP loop avoidance and prevention.
Understanding Ethernet Ring Protection Switching Functionality on page 112
Configuring Ethernet Ring Protection Switching on page 118
Example: Ethernet Ring Protection Switching Configuration on MX Routers
Example: Configuring Ethernet Ring Protection Switching on EX Series Switches
Ethernet Interfaces Feature Guide for Routing Devices
Acronyms on page 113
Ring Nodes on page 113
Ring Node States on page 113
Default Logging of Basic State Transitions on EX Series Switches on page 114
Failure Detection on page 114
Logical Ring on page 114
FDB Flush on page 114
Traffic Blocking and Forwarding on page 115
RPL Neighbor Node on page 115
RAPS Message Blocking and Forwarding on page 115
Dedicated Signaling Control Channel on page 116
RAPS Message Termination on page 116
Revertive and Non-revertive Modes on page 117
Multiple Rings on page 117
Node ID on page 117
Ring ID on page 117
Bridge Domains with the Ring Port (MX Series Routers Only) on page 117
Wait-to-Block Timer on page 117
Adding and Removing a Node on page 118
Copyright © 2017, Juniper Networks, Inc.