Juniper ACX1000 Configuration Manual page 345

Purpose
Action
Meaning
Purpose
Action
Meaning
Purpose
Action
Meaning
Purpose
Action
Copyright © 2017, Juniper Networks, Inc.
Verifying the Lock Status of the Slave
Verify that the slave clock is aligned to the master clock by checking the lock status of
the slave.
In operational mode, enter the
status of the slave.
The output displays information about the lock status of the slave. The output shows
whether the slave is aligned to the master clock or not, and the interface name configured
for PTP on the slave. The Master Source Port
clock when PTP over IPv4 is configured and the multicast MAC address of the source
when PTP over Ethernet is configured. For more information about the
lock-status operational command, see
Verifying the PTP Options on the Slave
Verify the PTP options that are set on the slave and the current status of the master.
In operational mode, enter the
slave.
The output displays information about the configured slave and the status of the slave.
For more information about the
in the .
CLI Explorer
Verifying the PTP Options and the Current Status of the Master
Verify the PTP options that are set for the master and its current status.
In operational mode, enter the
options for the master.
The output displays information about the configured master and the current status of
the master. For more information about the
see show ptp master in the
Verifying the Number and Status of the PTP Ports
Verify the number of PTP ports and their current status.
In operational mode, enter the
ports.
Chapter 9: Configuring Timing and Synchronization
run show ptp lock-status
field displays the address of the master
show ptp lock-status
command to display the configured
run show ptp slave
show ptp slave operational command, see show ptp slave
command to display the configured
run show ptp master
run show ptp master
CLI Explorer .
command to display the configured
run show ptp port
command to display the lock
run show ptp
in the CLI Explorer .
operational command,
287