Configuring Arp; Configuring A Static Arp Entry - H3C S3610-28P Operation Manual

Operation Manual – ARP
H3C S3610&S5510 Series Ethernet Switches
receiving the ARP reply into the static ARP entry. Now the entry can be used for
forwarding IP packets.
Note:
Usually ARP dynamically implements and automatically seeks mappings from IP
addresses to MAC addresses, without manual intervention.

1.2 Configuring ARP

1.2.1 Configuring a Static ARP Entry

A static ARP entry is effective when the device works normally. However, when a VLAN
or VLAN interface to which a static ARP entry corresponds is deleted, the entry, if
permanent, will be deleted, and if non-permanent and resolved, will become
unresolved.
Follow these steps to configure a static ARP entry:
Enter system view
Configure a permanent
static ARP entry
Configure a
non-permanent static
ARP entry
Caution:
The vlan-id argument must be the ID of an existing VLAN which corresponds to the
ARP entries. In addition, the Ethernet port following the argument must belong to that
VLAN. A VLAN interface must be created for the VLAN.
To do...
system-view
arp static ip-address
mac-address [ vlan-id
interface-type
interface-number ]
[ vpn-instance-name ]
arp static ip-address
mac-address
[ vpn-instance
vpn-instance-name ]
Use the command...
1-4
Chapter 1 ARP Configuration
Remarks
—
Required
No permanent static ARP
entry is configured by
default.
Required
No non-permanent static
ARP entry is configured
by default.