H3C S3610-28P Operation Manual page 553

Operation Manual – IPv4 Routing
H3C S3610&S5510 Series Ethernet Switches
Set a preference for the
matched routing protocol
Set a preferred value for
BGP routes
Set a tag value for RIP,
OSPF or IS-IS routes
Note:
The apply ip-address next-hop command does not apply to redistributed IPv4 routes.
6.5 Displaying and Maintaining the Routing Policy
Display BGP AS path ACL
information
Display BGP community
list information
Display BGP extended
community list information
Display IPv4 prefix list
statistics
Display routing policy
information
Clear IPv4 prefix list
statistics
6.6 Routing Policy Configuration Example
6.6.1 Applying Routing Policy When Redistributing IPv4 Routes
I. Network Requirements
Switch B exchanges routing information with Switch A via OSPF, with Switch C via
IS-IS.
To do...
apply preference
preference
apply preferred-value
preferred-value
apply tag value
To do...
display ip as-path
[ as-path-number ]
display ip community-list
[ basic-community-list-number |
adv-community-list-number ]
display ip extcommunity-list
[ ext-comm-list-number ]
display ip ip-prefix
[ ip-prefix-name ]
display route-policy
[ route-policy-name ]
reset ip ip-prefix
[ ip-prefix-name ]
Chapter 6 Routing Policy Configuration
Use the command...
Use the command...
6-10
Remarks
Optional
Not set by default
Optional
Not set by default
Optional
Not set by default
Remarks
Available in any
view
Available in user
view