Specifying The Source Interface For Establishing Tcp Connections - H3C S3610-28P Operation Manual

Operation Manual – IPv6 Routing
H3C S3610&S5510 Series Ethernet Switches
Note:
If you both reference a routing policy and use the command peer { ipv6-group-name |
ipv6-address } preferred-value value to set a preferred value for routes from a peer,
the routing policy sets a non-zero preferred value for routes matching it. Other routes
not matching the routing policy uses the value set with the command. If the preferred
value in the routing policy is zero, the routes matching it will also use the value set with
the command. For information about using a routing policy to set a preferred value,
refer to the peer { ipv6-group-name | ipv6-address } route-policy route-policy-name
{ import | export } command and the apply preferred-value preferred-value
command.

5.3.5 Specifying the Source Interface for Establishing TCP Connections

Follow these steps to specify the source interface for establishing TCP connections to a
BGP peer or peer group:
Enter system view
Enter BGP view
Enter IPv6 address family
view
Specify the source
interface for establishing
TCP connections to a
BGP peer or peer group
To do...
system-view
bgp as-number
ipv6-family
peer { ipv6-group-name |
ipv6-address }
connect-interface
interface-type
interface-number
Use the command...
5-5
Chapter 5 IPv6 BGP Configuration
Remarks
—
Required
—
Required
By default, BGP uses the
outbound interface of the
best route to the BGP
peer as the source
interface for establishing a
TCP connection.