H3C S3610-28P Operation Manual page 658

Operation Manual – IPv6 Routing
H3C S3610&S5510 Series Ethernet Switches
Match IPv6 BGP routes
having AS path attributes
specified in the AS path
list (s)
Match IPv6 BGP routes
having community
attributes in the specified
community list(s)
Match routes having the
specified cost
Match BGP routes having
extended attributes
contained in the extended
community list(s)
Match routes having
specified outbound
interface(s)
Match routes having the
specified route type
Match the routes having
the specified tag value
Note:
The if-match clauses of a route-policy are in logic AND relationship, namely, routing
information has to satisfy all if-match clauses before being executed with apply
clauses.
You can specify no or multiple if-match clauses for a routing policy. If no if-match
clause is specified, and the routing policy is in permit mode, all routing information
can pass the node; if in deny mode, no routing information can pass.
A routing policy should use a non VPN ACL for filtering.
To do...
if-match as-path
as-path-number&<1-16>
if-match community
{ basic-community-list-nu
mber [ whole-match ] |
adv-community-list-numb
er }&<1-16>
if-match cost value
if-match extcommunity
ext-comm-list-number&<1
-16>
if-match interface
{ interface-type
interface-number }&<1-16
>
if-match route-type
{ internal |
external-type1 |
external-type2 |
external-type1or2 |
is-is-level-1 |
is-is-level-2 |
nssa-external-type1 |
nssa-external-type2 |
nssa-external-type1or2 }
*
if-match tag value
Chapter 6 Routing Policy Configuration
Use the command...
6-7
Remarks
Optional
Not configured by default
Optional
Not configured by default
Optional
Not configured by default
Optional
Not configured by default
Optional
Not configured by default
Optional
Not configured by default
Optional
Not configured by default