Configuring A Priority For Ospfv; Configuring Ospfv3 Route Redistribution - H3C S3610-28P Operation Manual

Operation Manual – IPv6 Routing
H3C S3610&S5510 Series Ethernet Switches
Specify the maximum
number of load-balanced
routes

3.5.6 Configuring a Priority for OSPFv3

A router may run multiple routing protocols. The system assigns a priority for each
protocol. When these routing protocols find the same route, the route found by the
protocol with the highest priority is selected.
Follow these steps to configure a priority for OSPFv3:
Enter system view
Enter OSPFv3 view
Configure a priority for
OSPFv3

3.5.7 Configuring OSPFv3 Route Redistribution

Follow these steps to configure OSPFv3 route redistribution:
Enter system view
Enter OSPFv3 view
Specify a default cost for
redistributed routes
Redistribute routes from
another protocol, or
another OSPFv3 process
To do...
maximum
load-balancing
maximum
To do...
system-view
ospfv3 [ process-id ]
preference [ ase ]
[ route-policy
route-policy-name ]
preference
To do...
system-view
ospfv3 [ process-id ]
default cost value
import-route { isisv6
process-id | ospfv3
process-id | ripng
process-id | bgp4+
[ allow-ibgp ] | direct |
static } [ cost value | type
type | route-policy
route-policy-name ] *
Chapter 3 IPv6 OSPFv3 Configuration
Use the command...
Use the command...
Use the command...
3-9
Remarks
Optional
4 by default
Remarks
—
—
Optional
By default, the priority of
OSPFv3 interval routes is
10, and priority of
OSPFv3 external routes is
150.
Remarks
—
—
Optional
Defaults to 1
Required
Not configured by default