H3C S3610-28P Operation Manual page 865

Operation Manual – Multicast Protocol
H3C S3610&S5510 Series Ethernet Switches
Caution:
The reset command clears the information in the multicast routing table or the
multicast forwarding table, and thus may cause failure of multicast transmission.
When a routing entry is deleted from the multicast routing table, the corresponding
forwarding entry will also be deleted from the multicast forwarding table.
When a forwarding entry is deleted from the multicast forwarding table, the
corresponding route entry will also be deleted from the multicast routing table.
8.5 Configuration Examples
8.5.1 Multicast Static Route Configuration
I. Network requirements
All switches in the network support IP multicast.
Switch A, Switch B and Switch C run OSPF, and have no unicast routes to Switch
D.
Receiver can receive the multicast data from Source 1 through the path Switch A
–Switch B –Switch C.
Perform the following configuration so that Receiver can receive multicast data
from Source 2, which is outside the OSPF domain, through Switch C.
Chapter 8 Multicast Routing and Forwarding
8-12
Configuration