H3C S3610-28P Operation Manual page 1122

Operation Manual – Port Mirroring
H3C S3610&S5510 Series Ethernet Switches
Add ports
to the port
mirroring
group as
source
ports
Add a port
to the
mirroring
group as
the
destination
port
Note:
A local mirroring group is effective only when it has both source ports and the
destination port configured.
You must create a mirroring group before you can specify it.
It is not recommended to enable STP, RSTP or MSTP on the destination port;
otherwise, the mirroring function may be affected.
An aggregation port cannot be specified as a destination port.
A source port or a destination port cannot be a member port of the current mirroring
group.
You can configure multiple source ports for a mirroring group, but only one
destination port.
To do...
mirroring-group group-id
In system
mirroring-port
view mirroring-port-list { both |
inbound | outbound }
interface interface-type
interface-number
[ mirroring-group group-id ]
mirroring-port { both |
In interface
inbound | outbound }
view
quit
In system mirroring-group group-id
view monitor-port monitor-port-id
interface interface-type
interface-number
In interface
view
[ mirroring-group group-id ]
monitor-port
Chapter 1 Port Mirroring Configuration
Use the command...
1-4
Remarks
You can add ports to
a port mirroring group
as source ports in
either system view or
interface view.
In system view, you
can add multiple
ports to a port
mirroring group at
one time. While in
interface view, you
can only add the
current port to a port
mirroring group.
You can add a
destination port to a
port mirroring group
in either system view
or interface view.
They achieve the
same purpose.