H3C S3610-28P Operation Manual page 762

Operation Manual – Multicast Protocol
H3C S3610&S5510 Series Ethernet Switches
II. Network diagram
Figure 5-3 Network diagram for IGMP configuration
III. Configuration procedure
1) Configure the IP addresses of the switch interfaces and configure a unicast routing
protocol
Configure the IP address and subnet mask of each interface as per
detailed configuration steps are omitted here.
Configure the OSPF protocol for interoperation among the switches. Ensure the
network-layer interoperation among Switch A, Switch B and Switch C on the PIM
network and dynamic update of routing information among the switches through a
unicast routing protocol. The detailed configuration steps are omitted here.
2) Enable IP multicast routing, and enable IGMP on the host-side interfaces
# Enable IP multicast routing on Switch A, and enable IGMP (version 3) on
VLAN-interface 100.
<SwitchA> system-view
[SwitchA] multicast routing-enable
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] igmp enable
[SwitchA-Vlan-interface100] igmp version 3
[SwitchA-Vlan-interface100] quit
# Enable IP multicast routing on Switch B, and enable IGMP (version 2) on
VLAN-interface 200.
5-15
Chapter 5 IGMP Configuration
Figure 5-3. The