H3C S3610-28P Operation Manual page 1327

Operation Manual – NQA
H3C S3610&S5510 Series Ethernet Switches
2) Network diagram
Figure 1-10 Network diagram for the DLSw test
3) Configuration procedure
Note:
For the configuration of DLSw devices, refer to the related manuals of routers
supporting the DLSw function.
Configure Switch A:
# Enable the NQA client, create a DLSw test group, and configure related test
parameters.
<SwitchA> system-view
[SwitchA] nqa-agent enable
[SwitchA] nqa admin dlsw
[SwitchA-nqa-admin-dlsw] test-type dlsw
[SwitchA-nqa-admin-dlsw] destination-ip 10.2.2.2
# Enable the DLSw test.
[SwitchA-nqa-admin-dlsw] test-enable
# View the test results with the display nqa results command.
[SwitchA-nqa-admin-dlsw] display nqa results admin dlsw
NQA entry(admin admin, tag dlsw) test result:
Destination ip address: 10.2.2.2
Send operation times: 1
Min/Max/Average Round Trip Time: 5/5/5
Square-Sum of Round Trip Time: 25
Last succeeded test time: 2006-06-07 13:25:45.1
Extend result:
Packet lost in test: 0%
Failures due to Timeout: 0
Failures due to System Busy: 0
Failures due to Disconnect: 0
Failures due to No Connection: 0
Failures due to Sequence Error: 0
Receive response times: 1
1-26
Chapter 1 NQA Configuration