H3C S3610-28P Operation Manual page 1165

Operation Manual – SNMP-RMON
H3C S3610&S5510 Series Ethernet Switches
Create or update the MIB
view content for an SNMP
agent
Follow these steps to configure SNMPv1 and SNMPv2c:
Enter system view
Enable SNMP Agent
Configure SNMP Agent
system information
Config
ure
SNMP
NMS
acces
s right
Configure the maximum
size of an SNMP packet
that can be received or
sent by an SNMP agent
To do...
snmp-agent mib-view
{ excluded | included }
view-name oid-tree
[ mask mask-value ]
To do...
system-view
snmp-agent
snmp-agent sys-info
{ contact sys-contact |
location sys-location |
version { { v1 | v2c | v3 }*
| all } }
Config snmp-agent community
Config
ure a
{ read | write }
ure
comm community-name [ acl
directl
unity acl-number | mib-view
y
name view-name ]*
snmp-agent group { v1 |
Config v2c } group-name
ure an [ read-view read-view ]
SNMP [ write-view write-view ]
group [ notify-view notify-view ]
Config
[ acl acl-number ]
ure
indirec
Add a
tly
new snmp-agent usm-user
user to { v1 | v2c } user-name
an group-name [ acl
SNMP acl-number ]
group
snmp-agent packet
max-size byte-count
Use the command...
Use the command...
1-4
Chapter 1 SNMP Configuration
Remarks
Optional
MIB view name is
ViewDefault and OID is 1
by default.
Remarks
—
Optional
Disabled by default
You can enable SNMP
Agent through this
command or any
commands that begin with
snmp-agent.
Required
The defaults are as
follows:
Hangzhou H3C
Technologies Co.,Ltd. for
contact,
Hangzhou China for
location and SNMP v3 for
the version.
Use either approach.
Both commands can be
used to configure SNMP
NMS access rights. The
second command was
introduced to be
compatible with SNMPv3.
The community name
configured on NMS should
be consistent with the
username configured on
the Agent.
Optional
15,00 bytes by default