Information Center Configuration Examples - H3C S3610-28P Operation Manual

Operation Manual – Information Center
H3C S3610&S5510 Series Ethernet Switches
Note:
Support for the display logfile buffer and display logfile summary commands varies
with devices.

1.4 Information Center Configuration Examples

1.4.1 Outputting Log Information to a Unix Log Host
I. Network requirements
Send log information to a Unix log host with an IP address of 1.2.0.1/16;
Log information with severity higher than informational will be output to the log
host;
The source modules are ARP and IP.
II. Network diagram
Figure 1-1 Network diagram for outputting log information to a Unix log host
III. Configuration procedure
1) Configuring the device
# Enable information center.
<Sysname> system-view
[Sysname] info-center enable
# Specify the channel to output log information to the log host (loghost by default,
optional).
[Sysname] info-center loghost 1.2.0.1 channel loghost
# Disable the output of log, trap, and debug information of all modules to the log host.
[Sysname] info-center source default channel loghost debug state off log state
off trap state off
Chapter 1 Information Center Configuration
1-15