Configuring A Ripng Route Filtering Policy; Configuring A Priority For Ripng - H3C S3610-28P Operation Manual

Operation Manual – IPv6 Routing
H3C S3610&S5510 Series Ethernet Switches
2.3.3 Advertising a Default Route
Follow these steps to advertise a default route:
Enter system view
Enter interface view
Advertise a default route
Note:
With this feature enabled, a default route is advertised via the specified interface
regardless of whether the default route is available in the local IPv6 routing table.

2.3.4 Configuring a RIPng Route Filtering Policy

You can reference a configured IPv6 ACL or prefix list to filter received/advertised
routing information as needed. For filtering outbound routes, you can also specify a
routing protocol from which to filter routing information redistributed.
Follow these steps to configure a RIPng route filtering policy:
Enter system view
Enter RIPng view
Configure a filter policy to
filter incoming routes
Configure a filter policy to
filter outgoing routes

2.3.5 Configuring a Priority for RIPng

Any routing protocol has its own protocol priority used for optimal route selection. You
can set a priority for RIPng manually. The smaller the value is, the higher the priority is.
To do...
system-view
interface interface-type
interface-number
ripng default-route
{ only | originate } [ cost
cost ]
To do...
system-view
ripng [ process-id ]
filter-policy
{ acl6-number |
ipv6-prefix
ipv6-prefix-name } import
filter-policy
{ acl6-number |
ipv6-prefix
ipv6-prefix-name } export
[ protocol [ process-id ] ]
Chapter 2 IPv6 RIPng Configuration
Use the command...
Use the command...
2-6
Remarks
––
––
Required
Not advertised by default
Remarks
––
––
Required
By default, RIPng does
not filter incoming routing
information.
Required
By default, RIPng does
not filter outgoing routing
information.