Oam Configuration; Oam Configuration Task List; Configuring Basic Oam Basic Functions - H3C S3610-28P Operation Manual

Operation Manual – OAM
H3C S3610&S5510 Series Ethernet Switches

1.2 OAM Configuration

1.2.1 OAM Configuration Task List

Complete the following tasks to configure OAM:

Configuring Basic OAM Basic Functions

Configuring the Periods and Thresholds for OAM Link
Error Event Detection
Enabling OAM Loopback Testing
1.2.2 Configuring Basic OAM Basic Functions
Follow these steps to configure basic OAM functions:
Enter system view
Enter Ethernet port view
Set OAM operating mode
Enable OAM on the
current port
Note:
OAM connections can be initiated only by OAM entities operating in active OAM
mode, while those operating in passive mode wait and respond to the connection
requests sent by their peers.
No OAM connection can be established between two OAM entities operating in
passive OAM mode.
With OAM enabled, you cannot change the OAM operating mode. To do so, you
need to disable OAM first.
Task
To do...
system-view
interface interface-type
interface-number
oam mode { active |
passive }
oam enable
Use the command...
1-5
Chapter 1 OAM Configuration
Remarks
Required
Optional
Optional
Remarks
—
—
Optional
The default is active OAM
mode.
Required
OAM is disabled by
default.
After OAM is enabled, the
OAM entity tries to
establish OAM connection
with its peer.