H3C S3610-28P Operation Manual page 850

Operation Manual – Multicast Protocol
H3C S3610&S5510 Series Ethernet Switches
# Configure Switch C as a static RPF peer of Switch D.
[SwitchD]
less-equal 32
[SwitchD] msdp
[SwitchD-msdp] peer 192.168.3.2 connect-interface vlan-interface 102
[SwitchD-msdp] static-rpf-peer 192.168.3.2 rp-policy list-c
[SwitchD-msdp] quit
# Configure Switch C as a static RPF peer of Switch F.
[SwitchF]
less-equal 32
[SwitchF] msdp
[SwitchF-msdp] peer 192.168.3.2 connect-interface vlan-interface 102
[SwitchF-msdp] static-rpf-peer 192.168.3.2 rp-policy list-c
[SwitchF-msdp] quit
5) Verify the configuration
Carry out the display bgp peer command to view the BGP peering relationships
between the switches. If the command gives no output information, a BGP peering
relationship has not been established between the switches.
When the multicast source S1 sends multicast information, receivers in PIM-SM 2 and
PIM-SM 3 can receive the multicast data. You can use the display msdp brief
command to view the brief information of MSDP peering relationships between the
switches. For example:
# View the brief MSDP peer information on Switch C.
[SwitchC] display msdp brief
MSDP Peer Brief Information
Configured
2
Peer's Address
192.168.3.1
192.168.1.2
# View the brief MSDP peer information on Router D.
[SwitchD] display msdp brief
MSDP Peer Brief Information
Configured
1
Peer's Address
192.168.3.2
# View the brief MSDP peer information on Switch F.
ip ip-prefix list-c
ip ip-prefix list-c
Up Listen
2 0
State
UP
UP
Up Listen
1 0
State
UP
permit 192.168.0.0
permit 192.168.0.0
Connect
0
Up/Down time AS
01:07:08 ?
00:16:39 ?
Connect
0
Up/Down time AS
01:07:09 ?
7-30
Chapter 7 MSDP Configuration
16 greater-equal
16 greater-equal
Shutdown Down
0 0
SA Count Reset Count
8 0
13 0
Shutdown Down
0 0
SA Count Reset Count
8 0
16
16