H3C S3610-28P Operation Manual page 1108

Operation Manual – QoS
H3C S3610&S5510 Series Ethernet Switches
7.3 Applying Aggregation CAR
7.3.1 Applying Aggregation CAR to a Port or a Port Group
I. Configuration Prerequisites
Aggregation CAR-related parameters are determined.
The port or port group to which aggregation CAR is to be applied is determined.
ACL rules used for packet matching are determined. Refer to the ACL module in
this manual for detailed configuration.
II. Configuration Procedure
Follow these steps to apply aggregation CAR to a port or port group:
To do...
Enter system view
Enter
port
view or
port
group
view
Apply aggregation
CAR
III. Configuration Example
Apply aggregation CAR to Ethernet 1/0/1 and Ethernet 1/0/2 to set the maximum rate of
incoming traffic matching IPv4 ACL 2001 on the two ports to 1000 kbps and drop the
packets exceeding the specification.
Configuration procedure:
# Enter system view.
<Sysname> system-view
# Configure aggregation CAR aggcar-1.
[Sysname] qos car aggcar-1 aggregative cir 1000
# Apply the aggregation CAR aggcar-1 to the inbound direction of Ethernet 1/0/1 and
Ethernet 1/0/2.
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] qos car inbound acl 2001 name aggcar-1
Use the command...
system-view
Enter
interface interface-type
port
interface-number
view
Enter
port-group { manual
port
port-group-name |
group
aggregation agg-id }
view
qos car inbound acl [ ipv6 ]
acl-number name
global-car-name
Chapter 7 Aggregation CAR Configuration
7-2
Remarks
—
Perform either of the two
operations.
The configuration
performed in port view
applies to the current port
only. Configuration
performed in port group
view applies to all the ports
in the port group.
Required