H3C S3610-28P Operation Manual page 1347

Operation Manual – VRRP
H3C S3610&S5510 Series Ethernet Switches
1.2.6 Configuring VRRP Packet Attributes
I. Configuration prerequisites
Before configuring the relevant attributes of VRRP packets, you should first create the
standby group and configure the virtual IP address.
II. Configuration procedure
Follow these steps to configure VRRP packet attributes:
Enter system view
Enter the specified
interface view
Configure the
authentication mode and
authentication key when
the standby groups send
and receive VRRP
packets
Configure the time interval
for the Master in the
standby group to send
VRRP advertisement
Disable TTL check on
VRRP packets
Note:
You may configure different authentication modes and authentication keys for the
standby groups on an interface. However, the members of the same standby group
must use the same authentication mode and authentication key.
Factors like excessive traffic or different timer setting on switches can cause the
Backup timer to time-out abnormally and trigger a change of the state. To solve this
problem, you can prolong the time interval to send VRRP packets and configure a
preemption delay.
To do...
system-view
interface interface-type
interface-number
vrrp vrid virtual-router-id
authentication-mode
{ md5 | simple } key
vrrp vrid virtual-router-id
timer advertise
adver-interval
vrrp un-check ttl
Use the command...
1-14
Chapter 1 VRRP Configuration
Remarks
—
—
Optional
Authentication is not
performed by default
Optional
1 second by default
Optional
Enabled by default
Do not create a standby
group before executing
this command.