H3C S3610-28P Operation Manual page 1326

Operation Manual – NQA
H3C S3610&S5510 Series Ethernet Switches
Failures due to Other Errors: 0
1.2.9 Configuring the DLSw Test
Data Link Switching (DLSw) was jointly developed by advanced peer-to-peer
networking (APPN), implementers workshop (AIW) and the Data-Link Switching related
interest group (DLSw RIG) for transmitting Systems Network Architecture (SNA) traffic
over a TCP/IP network. For the detailed description of DLSw, refer to the related
manuals of routers supporting the DLSw function.
The DLSw test is used to test the response time of the DLSw device.
I. Configuration prerequisites
Before the DLSw test, a TCP connection can be set up between the NQA client and the
specified device and the DLSw function must be enabled on the specified device.
II. Configuration procedure
Follow these steps to configure the DLSw test:
Enter system view
Enable the NQA client
Create an NQA test group
and enter its view
Set the test type to DLSw
Configure a destination
address for a test
Configure common
optional parameters
Enable the NQA test
View the test results
III. Configuration example
1) Network requirements
Use the NQA DLSw function to test the response time of the DLSw device.
To do...
system-view
nqa-agent enable
nqa admin-name
operation-tag
test-type dlsw
destination-ip ip-address
Refer to
Parameters for NQA
test-enable
display nqa results
[ admin-name operation-tag ]
Use the command...
Configuring Optional
Tests.
1-25
Chapter 1 NQA Configuration
Remarks
—
Required
—
Required
Required
Optional
Required
Required
Available in any view.