H3C S3610-28P Operation Manual page 1359

Operation Manual – VRRP
H3C S3610&S5510 Series Ethernet Switches
Virtual IP Ping : Enable
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Track IF
Virtual IP
Master IP
# If VLAN-interface 3 on Switch A is not available, the detailed information of standby
group 1 on Switch B is displayed.
[SwitchB-Vlan-interface2] display vrrp verbose
IPv4 Standby Information:
Run Method
Virtual IP Ping : Enable
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
The above information indicates that if VLAN-interface 3 on Switch A is not available,
the priority of Switch A is reduced to 80 and it becomes the backup. Switch B becomes
the master and packets sent from Host A to Host B are forwarded by Switch B.
1.4.3 Multiple VRRP Standby Group Configuration Example
I. Network requirements
In the segment 202.38.160.0/24, some hosts use 202.38.160.111/24 as their
default gateway and some hosts use 202.38.160.112/24 as their default gateway.
Load sharing and mutual backup between default gateways can be implemented
by using VRRP standby groups.
: Vlan-interface2
: 1
: UP
: 110
: YES
: SIMPLE TEXT
: Vlan-interface3
: 202.38.160.111
: 202.38.160.2
: VIRTUAL-MAC
: Vlan-interface2
: 1
: UP
: 100
: YES
: SIMPLE TEXT
: 202.38.160.111
: 0000-5e00-0101
: 202.38.160.2
1-26
Chapter 1 VRRP Configuration
Adver. Timer : 5
State : Backup
Run Pri : 80
Delay Time : 0
Key : hello
Pri Reduced : 30
Adver. Timer : 5
State : Master
Run Pri : 100
Delay Time : 0
Key : hello