Configuring Ipv6 Bgp Route Redistribution - H3C S3610-28P Operation Manual

Operation Manual – IPv6 Routing
H3C S3610&S5510 Series Ethernet Switches
Enable the state change
logging for a peer or peer
group
Note:
Refer to the part discussing IPv4 routing commands for information about the
log-peer-change command.
5.4 Controlling Route Distribution and Reception
The task includes routing information filtering, routing policy application and route
dampening.
5.4.1 Prerequisites
Before configuring this task, you have:
Enabled the IPv6 function
Configured the IPv6 BGP basic functions

5.4.2 Configuring IPv6 BGP Route Redistribution

Follow these steps to configure IPv6 BGP route redistribution and filtering:
Enter system view
Enter BGP view
Enter IPv6 address family
view
Enable default route
redistribution into the IPv6
BGP routing table
Enable route
redistribution from
another routing protocol
To do...
peer { ipv6-group-name |
ipv6-address }
log-change
To do...
system-view
bgp as-number
ipv6-family
default-route imported
import-route protocol
[ process-id ] [ med
med-value | route-policy
route-policy-name ]*
Use the command...
Use the command...
5-8
Chapter 5 IPv6 BGP Configuration
Remarks
Optional
Enabled by default
Remarks
—
—
—
Optional
Not enabled by default
Required
Not enabled by default