Chapter 2 Mce Configuration; Configuring A Vpn Instance; Vpn Instance Configuration Tasks; Setting The Operation Mode Of The Switch To Mce - H3C S3610-28P Operation Manual

Operation Manual – MCE
H3C S3610&S5510 Series Ethernet Switches

Chapter 2 MCE Configuration

Note:
For detailed information on the routing protocol configuration mentioned in this chapter,
see the IPv4 Routing module of this manual.

2.1 Configuring a VPN Instance

2.1.1 VPN Instance Configuration Tasks

Table 2-1 Configure a VPN instance
Configuring the operation
mode to MCE
Create a VPN instance
Associate the VPN instance
with an interface
Configure the route-related
attributes for the VPN instance

2.1.2 Setting the Operation Mode of the Switch to MCE

The switch must work in the operation mode of MCE to support MCE.
Table 2-2 Set the operation mode of the switch to MCE
Operation
Enter system view
Set the operation
mode of the switch
to MCE
Operation
Command
system-view
switch-mode
mce
Description
See
Required
Mode of the Switch to
See
Required
Instance"
See
Required
Instance with an
See
Required Route-related Attributes for a
VPN
—
Required
By default, the device works in the
default mode and does not support MCE.
2-1
Chapter 2 MCE Configuration
Related section
2.1.2 "Setting the Operation
MCE"
2.1.3 "Creating a VPN
2.1.4 "Associating an VPN
Interface"
2.1.5 "Configuring the
Instance"
Description