H3C S3610-28P Operation Manual page 1144

Operation Manual – Cluster Management
H3C S3610&S5510 Series Ethernet Switches
Enter cluster view
Configure the private IP
address range for
member devices on a
device which is to be
configured as the
management device
Establish a cluster
automatically
1.3.8 Configuring Communication Between the Management Device and the
Member Devices Within a Cluster
In a cluster, the management device and member devices communicate by sending
handshake packets to maintain connection between them. You can configure interval of
sending handshake packets and the holdtime of a device on the management device.
This configuration applies to all member devices within the cluster.
Follow these steps to configure communication between the management device and
the member devices within a cluster:
Enter system view
Configure the interval to
send handshake packets
Configure the holdtime of
a device
1.3.9 Configuring Cluster Member Management
I. Adding/Removing a member device
You can manually add a candidate device to a cluster, or remove a member device from
a cluster. These operations must be done through the management device, otherwise
you will be prompted with an error message.
To do...
cluster
ip-pool
administrator-ip-address
{ mask | mask-length }
auto-build [ recover ]
To do...
system-view
timer interval-time
holdtime seconds
Chapter 1 Cluster Management Configuration
Use the command...
Use the command...
1-14
Remarks
—
Required
For a cluster to work
normally, the IP
addresses of the VLAN
interfaces of the
management device and
member devices must not
be in the same network
segment as the cluster
address pool.
Required
Remarks
—
Optional
10 seconds by default
Optional
60 seconds by default