H3C S3610-28P Operation Manual page 1353

Operation Manual – VRRP
H3C S3610&S5510 Series Ethernet Switches
1.3.7 Displaying and Maintaining VRRP for IPv6
To do...
Display VRRP
status
Display VRRP
statistics
Remove VRRP
statistics
1.4 IPv4-Based VRRP Configuration Examples
This section provides these configuration examples:
Single VRRP Standby Group Configuration Example
VRRP Interface Tracking Configuration Example
Multiple VRRP Standby Group Configuration Example
1.4.1 Single VRRP Standby Group Configuration Example
I. Network requirements
Host A needs to access Host B on the Internet, using 202.38.160.111/24 as its
default gateway.
Switch A and Switch B belong to standby group 1 with the virtual IP address of
202.38.160.111.
If Switch A operates normally, packets sent from Host A to Host B are forwarded
by Switch A; if Switch A fails, packets sent from Host A to Host B are forwarded by
Switch B.
Use the command...
display vrrp ipv6 [verbose] [ interface
interface-type interface-number [ vrid
virtual-router-id ] ]
display vrrp ipv6 statistics [ interface
interface-type interface-number [vrid
virtual-router-id ] ]
reset vrrp ipv6 statistics [interface
interface-type interface-number [vrid
virtual-router-id ] ]
1-20
Chapter 1 VRRP Configuration
Remarks
Available in any
view
Available in any
view
Available in user
view