Setting To Output System Information To A Log Host - H3C S3610-28P Operation Manual

Operation Manual – Information Center
H3C S3610&S5510 Series Ethernet Switches
II. Enabling the display of system information on a monitor terminal
After setting to output system information to a monitor terminal, you need to enable the
associated display function in order to display the output information on the monitor
terminal.
Follow these steps to enable the display of system information on a monitor terminal:
Enable the monitoring of
system information on a
monitor terminal
Enable the display of
debug information on a
monitor terminal
Enable the display of log
information on a monitor
terminal
Enable the display of trap
information on a monitor
terminal

1.2.4 Setting to Output System Information to a Log Host

Enter system view
Enable information center
Name the channel with a
specified channel number
Specify a log host and
configure the parameters
when system information
is output to the log host
Configure the source
interface through which
log information can be
output to a log host
To do... Use the command...
terminal monitor
terminal debugging
terminal logging
terminal trapping
To do...
system-view
info-center enable
info-center channel
channel-number name
channel-name
info-center loghost
host-ip [ channel
{ channel-number |
channel-name } ] [ facility
local-number ] *
info-center loghost
source interface-type
interface-number
Chapter 1 Information Center Configuration
Use the command...
1-10
Remarks
Required
Enabled on the console
disabled on the monitoring
terminal by default.
Required
Disabled by default
Optional
Enabled by default
Optional
Enabled by default
Remarks
—
Optional
Enabled by default
Optional
Refer to Table 1-2
default channel names.
Required
Disabled by default with
channel 2 as the default
channel when enabled.
Optional
No source interface is
configured by default, and
the system selects an
interface as the source
interface.
for