Configuring Route Distribution Policy - H3C S3610-28P Operation Manual

Operation Manual – IPv6 Routing
H3C S3610&S5510 Series Ethernet Switches
Note:
If the default-route imported command is not configured, using the import-route
command cannot redistribute any IGP default route.
5.4.3 Advertising a Default Route to a Peer/Peer Group
Follow these steps to configure to advertise default route to a peer/peer group:
Enter system view
Enter BGP view
Enter IPv6 address family
view
Advertise a default route
to a peer/peer group
Note:
With the peer default-route-advertise command used, the local router advertises a
default route with itself as the next hop to the specified peer/peer group, regardless of
whether the default route is available in the routing table.

5.4.4 Configuring Route Distribution Policy

Follow these steps to configure policies for route distribution:
Enter system view
Enter BGP view
Enter IPv6 address family
view
Configure outbound route
filtering
To do...
system-view
bgp as-number
ipv6-family
peer { ipv6-group-name |
ipv6-address }
default-route-advertise
[ route-policy route-policy-name ]
To do...
system-view
bgp as-number
ipv6-family
filter-policy
{ acl6-number |
ipv6-prefix
ipv6-prefix-name } export
[ protocol process-id ]
Use the command...
Use the command...
5-9
Chapter 5 IPv6 BGP Configuration
Remarks
—
Required
—
Required
Not advertised by
default
Remarks
—
Required
—
Required
Not configured by default